Danfoss SET 3E User Manual download pdf (Page 4)

3060

Installation

1. Remove lower setting dial. Set all four tappets to top

of upper dial. Unscrew 4BA screw and remove outer

case.

2. Slacken two screws securing plug-in module to

backplate and separate module from backplate by

pulling upwards.

3. Fix backplate to wall (3 hole ﬁ xing).

4. Referring to wiring diagrams below and opposite

make electrical connections as shown (as applicable).

The diagrams indicate that terminals 3 and 5 are not

internally connected to the programmer and may

therefore be used as spare wiring terminals if required.

5. Ease of installation can be achieved by the use of the

Danfoss Randall Wiring Centre which is obtainable

from most Builders Merchants and Distributors.

NOTE: If a Wiring Centre is used follow the

installation instructions included with that unit and

not the following wiring diagrams.

6. Secure cable cores under cable clamp.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Danfoss SET 3E User Manual Page 4