Danfoss TP4000 Range User Manual download pdf

Fig.1

TP4000-RF User Instructions

Fig.2

Before programming the thermostat press and release the RESET button to restart

the unit. (Fig. 1)

Setting the Clock and Day

The time is set in the factory and therefore it will not normally be necessary to do

this on site. Changes between summer and winter time are handled automatically

by the unit.

Accepting the Factory Pre-settings

The TP4000-RF has pre-set times already programmed in, which often suit most

people (see table below).

To adjust the factory pre-settings & set your own time and temperature

programmes

a) Press PROG (Fig. 2) Until 1st pre-set time and temperature appears in display

(Fig. 3).

b) Use + or – buttons (Fig. 4) to adjust the TIME (press and hold to change in 10

min increments).

c) Use Λ or V buttons (Fig. 5) to adjust the TEMPERATURE.

d) Press PROG (Fig. 2) to move to next preset time & temp (Event 2) (Fig. 6).

e) Repeat steps b, c & d for programming Events 3, 4, 5 & 6.

Returning to RUN mode

Press PROG (Fig. 2) – the colon in the LCD display will start to ﬂash (Fig. 7).

Temporary User Overrides

Fig.5

Fig.4

Fig.6

Fig.7

Event Time Temp. °C

1 06:30 20

2 08:30 15

3 11:30 20

4 13:30 15

5 16:30 21

6 22:30 15

RESET

Fig.3

Fig.9

Fig.10

Selection of time

or actual room

temperature in main

LCD display

Temporary

override of

programmed

temperature

press

together

Frost

Protection

Fig.8

The TP4000-RF has several useful overrides which can be selected without aﬀecting

the thermostat programming.

• Selection of time or actual room temperature in main LCD display – press +

and – together to change between settings (Fig. 8).

• Temporary override of programmed temperature – press Λ or V until required

temperature is displayed (override will automatically cancel at beginning of next

programmed event) (Fig. 9).

• Frost Protection – a constant low temperature can be selected whilst away from

home - press Λ and V together (Fig.10). Then use Λ or V to select the required

temperature. To return to automatic programming press Λ and V together

again.

The TP4000-RF is both a programmer and a room thermostat. It allows you to programme

up to 6 times and temperatures at which your heating will come on and go oﬀ each

day.

1 2

Summary of Contents

Page 1 - TP4000-RF User Instructions

Fig.1TP4000-RF User InstructionsFig.2Before programming the thermostat press and release the RESET button to restart the unit. (Fig. 1)Setting the Clo

Page 2 - Battery Replacement

Danfoss Randall LtdAmpthill RoadBedford, MK42 9ERTel: 0845 1217 400Fax: 0845 1217 515Email: [email protected]: www.danfoss-randall.co.

Danfoss TP4000 Range User Manual

Browse online or download User Manual for Thermostats Danfoss TP4000 Range. TP4000-RF User Guide

Summary of Contents

More documents for Thermostats Danfoss TP4000 Range

Comments to this Manuals

Danfoss TP4000 Range User Manual

Browse online or download User Manual for Thermostats Danfoss TP4000 Range. TP4000-RF User Guide

Summary of Contents

More documents for Thermostats Danfoss TP4000 Range

Comments to this Manuals

Related products and manuals for Thermostats Danfoss TP4000 Range