Danfoss TS715 Si User Manual download pdf (Page 5)

Danfoss Heating

• The wallplate must be securely mounted either directly to the

wall using suitable wood screws or to a ﬂ ush mounted 1-gang

electrical accessory box using M3.5 screws.

• Cable access can either be from behind for concealed cabling, or

from below for surface cabling. If surface cable is used, cut out

cable access slot on plug-on module prior to mounting.

• For wiring connections refer to diagram below.

TS715 Si models are double insulated and do not require an

earth connection, however a parking terminal is provided on the

wallplate. This is clearly marked with an Earth symbol.

• Prior to mounting the plug-on module, DIL switches on the rear

of the plug-on module must be set. See diagram on page 6 for

available options.

• Mount plug-on module to wallplate by locating tabs on top of

wallplate in apertures on rear of module, hinge down and press

ﬁ rmly to wallplate before tightening securing screws on bottom

of wallplate.

Please Note:

Always switch oﬀ mains ﬁ rst and never ﬁ t programmer to a live

wallplate.

Please Note:

Link terminals L and 1 for

standard mains voltage

operated systems.

On 24 volt models power

supply must be wired to

A & B on wallplate.

3.1 Wiring

For wiring conversion tables please see pages 10-13).

COM

OFF

230 V

fused 3A

TS715 (3066 12/01)

1 2 3 4 5 6 7 8 9 10 ... 15 16

No comments

Danfoss TS715 Si User Manual Page 5