Danfoss TripleLynx CN Installation Manual download pdf (Page 159)

Configuration at a PC

Solar-Log1000, 500: Setting the inverter order (Basic/Inverter order)-

Solar-Log

1000/500/200

Installation 159 of 268

2 Click on the desired inverter in the list

 The inverter is transferred into the group definition box.

 Section with data organisation options

Changing the inverter order also affects the data inside Solar-Log™.

There are 3 options for re-organising the data:

– Leave data unchanged (e.g. inverter exchange)

If an inverter has been replaced due to a fault and therefore has to be

re-detected and integrated with the system, then the order of the invert-

ers may change. In this case, the new order has to be configured in this

dialogue box. However, the data does not have to be re-sorted – from

the point of view of the data logger, nothing has changed.

– Reorganising data to new positions (e.g. for extensions)

If the system has been expanded, or if the existing system is to be re-

sorted with data already logged, it is important for the inverter data to be

re-sorted as well. Otherwise, it is no longer possible to assign the data.

Data reorganisation can take some time, depending on the amount of

data already registered. The reorganisation process should never be in-

terrupted!

– Erase all data (recommended at initial setup)

Note: Always select this option if the system is being set up for the first

time. This causes the few test data to be deleted and the Solar-Log™

can then start registering data with a clean database.

3 When the inverter order has been applied in full and the desired data or-

ganisation has been activated, click on Save.

 When the settings are saved, the Solar-Log™ is restarted.

1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 267 268

No comments

Danfoss TripleLynx CN Installation Manual Page 159