Danfoss TripleLynx CN Installation Manual download pdf (Page 223)

Solar-Log1000: Configuration at the unit

Configuring the inverter data (Basic/Inverter)

Solar-Log

1000/500/200

Installation 223 of 268

10.8 Configuring the inverter data (Basic/Inverter)

Inverter configuration consists of a number of subdialog boxes, but only the

first two are important for the initial configuration.

The other settings are related to system monitoring and graph scaling, which

are all already pre-set with realistic values. Nothing usually needs to be

changed here.

The following individual dialogues are available for inverter configuration:

 Changing the inverter data

 Assigning a new number

(only for inverters without their own addressing function)

 Changing the name

 Entering a pulse factor (only or S0 meter)

 Setting the S0 meter (only for S0 meter)

 Setting the module and power data

 Configuring the monitoring

 Configuring the graph display

All inverter dialogue boxes apply only to the inverters that have been selected.

1 Select Config./Basic/Inverter from the menu.

 A dialogue box opens for selecting the inverters.

2 To select an inverter, touch the corresponding Number

 A list of the inverters available in the initial configuration is displayed.

3 Select the desired inverter, then confirm with Select

Changing the inverter data



Note

The entries in the inverter configuration dialogue boxes shown in the above

example will differ depending on the inverter and the interface.

1 2 ... 218 219 220 221 222 223 224 225 226 227 228 ... 267 268

No comments

Danfoss TripleLynx CN Installation Manual Page 223